en

use of vertical roller mill from gjsohcat's blog

During the production and use of vertical roller mill, the circulation air duct will be blocked. Here,ZENITH reminds everyone to stop the material in time and check the cause of blockage of the air duct. After the inspection, the material can be ground. Powder production. What are the reasons for the blockage of the air duct, the following is a brief introduction.


Too much or too little material will cause the vertical roller mill to be insufficiently ground. The finished powder can not be discharged in the circulation duct under the action of the blower in time, thus increasing the working load of the blower, causing the material to accumulate in the air duct, eventually leading to the air duct. 


Blocked. Therefore, when feeding the vertical roller mill, ensure that the material is continuously and evenly distributed to avoid the phenomenon of air passage blockage.


Previous post     
     Next post
     Blog home

The Wall

No comments
You need to sign in to comment

Post

By gjsohcat
Added Jun 24

Rate

Your rate:
Total: (0 rates)

Archives

Password protected photo
Password protected photo
Password protected photo